Error 1048

When describing surfaces for a Zone, there will generally be four walls, and floor and a ceiling/roof. Looking at the geometry of these inputs, it would not be possible that any individual surface in that zone could be larger than all of the remaining surfaces. This indicates either an input error for the square footages, or there are surfaces that have not been included when describing the Zone, and the CEC Compliance Manager will not run.

Note that interior surfaces are included in this tabulation, so be sure interior surfaces in other zones have the “Adjacent To” set properly so this Zone includes that surface in the tabulation.

Check your inputs for this Zone and verify the correct square footages for each surface and make sure you have both floors and ceiling/roofs input.

Please log in to rate this.
0 people found this helpful.


Category: Errors
Tags:

← Error 1048

Comments are closed